deflections

英 [dɪˈflɛkʃənz]

美

n.  (尤指击中某物后)突然转向，偏斜，偏离
deflection的复数

柯林斯词典

• N-VAR 偏斜;偏转
  Thedeflectionof something means making it change direction.
  1. ...the deflection of light as it passes through the slits in the grating.
     光线通过光栅狭缝时的偏转
• (体育运动中球击中某物后的)转向，变向
  In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

双语例句

• But, more significantly, the overturning moment and the shear deflections produced by lateral forces are much larger and must be carefully provided for.
  更重要的是侧向里所产生的倾覆力矩和剪力变形要大的多，必要谨慎设计来保证。
• Now the trace you notice on the left side has very few and very sharp deflections.
  现在大家注意到左侧的变位，很少但是很剧烈。
• The major application of these data is to define the control deflections required to stabilize the vehicle.
  这些数据的主要应用是确定稳定飞行器所需要的控制偏角。
• In geometric nonlinearity, the effects of instability produced by axial forces, the bowing of the deformed members, and finite deflections have all been included.
  在几何非线性的影响下，所产生不稳定的轴向力、弯曲变形产生的弯矩，以及有限制的偏移量均包括在内。
• Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
  试验结果表明，支座边的裂缝严重削弱了板的承载力，降低了楼板的刚度，导致楼板的挠度过大。
• In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented.
  提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
• This renders the bearing like other self-aligning bearings, impervious to misalignments and shaft deflections.
  有这种装置的轴承就像自调整轴承，可以避免误差和轴倾斜。
• Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.
  垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度，来承担足够的荷载。
• The effects of deflections are evaluated during the process of calibrating the balance.
  变形影响是在天平校准的过程中测量的。
• The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
  本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后，进而提出了新的绝对挠度法。